. Depending on the project, there are different possibilities, from the materials of the pump composition, to the sizing of the complete ATEX system.
This type of ATEX pumps comply with compliance with Directive 2014/34 / EU, they can be installed in potentially explosive atmospheres according to the brand explained in the technical details.
They have the possibility of including a start and stop system for the pumps through level or pressure probes (also with ATEX characteristics if necessary) and filters that limit the access of suspended solids to the pump.
A range of cables and pipes are available depending on the type of application.
Cast iron open impeller to prevent clogging of mud and other small suspended solids.
Electric pumps produced with 5 m of electric cable included.
Temperature of the pumped liquid: max. +40 ° C.
Asynchronous 2-pole motor, 50 Hz, 2850 rpm.
Class F insulation.
Working voltage: single-phase 230 V, three-phase 400 V.
Tailored advisory service according to the type of pollutant, type of project and characteristics of the installation. We offer the complete installation and commissioning service of a complete ATEX system with or without a telemetry and data management system.
Contáctanos a email@example.com o al 872 080 542.
These pumps only need an outlet that corresponds to the voltage of the equipment (single-phase or three-phase). They can be connected to an electrical panel or install one for operation.
They do not have an emergency stop, and they cannot run dry, so the installation of a start-stop system is recommended. In the case of bilge pumps, a buoy is usually installed.
Collection of leachates in storage tanks, pumping of industrial wastewater from wells or collection of deposits.